New Generation Anode Monitor Installation Checklist
Product Support and Customer Service
For Further support visit our Contact Page
| ! | ? | X | Description | Comments, Exceptions, & Notes |
| Is the panel mounted at eye level? | ||||
| Is 110V supplied to panel? | ||||
| Is there a 0-10V signal from rectifier connected to channel #1? | ||||
| Does customer have Ethernet cord attached? | ||||
| Is panel grounded to earth ground? | ||||
| Is y-strainer cleaned out? | ||||
| Measure 24V power supply. | ||||
| Measure 5V power supply. | ||||
| Is plan view of cells attached to panel? | ||||
| Is sensor #1 attached to the proper channel in panel? | ||||
| With a volt ohm meter measure the current sensor signal (white) with no current flowing through sensor and it should be one half of supply voltage (step 7). | ||||
| If signal is not one half of supply voltage, then check red and black connections. | ||||
| Repeat step # 10 for sensors #1. | ||||
| If still not one half of supply voltage, then check white wire continuity back to sensor. | ||||
| Repeat 10-13 for all other sensors. | ||||
| Turn Power ON, do all Cells show ‘0’ when the Rectifier is zero V output? | ||||
| Is the Time & Date correct? |
Legend Description:
! - Needs Immediate attention ? - Some irregularity, probably ok X - Checked out fine